Brains do not seem to be of much account now a days.

Noting that, The leading feature of this case is its improbability...

Raed has another scoop.

Sloppy journalism?

Onnik Krikorian has the scoop.

There is a hole in your sock.

Who leaked such a feast?

Originally, this was all solid with a hole in it.

There's a hole here, and I shut this.

That's a lexicographical cop out, to say, miscellaneous technical senses.

There was a bullet hole in the windshield.

A can with a little hole and some duck tape.

The water leaked because there was a hole in the channel.

I know John Gage and Sun Microsystems are already on board for this, but there's lots of you we'd like to talk to.

This was announced as the N Gage platform or N Gage 2.0 in 2007, carrying on the N Gage name.

But this leaves us with a big gap in our knowledge.

You can't just drill a hole and pump it out.

GLOBO included a special report in its extremely popular weekend TV magazine FANTASTICO and here's the text (computer) translated into rough English.

And they use a red hot iron needle to make a hole through the muzzle.

And if you were to just poke a hole over here and put a third matchstick, you'll get a T joint.

Pinhole cameras can also be constructed by replacing the lens assembly in a conventional camera with a pinhole.

These were replaced in 1967 by the current, cupro nickel type, along with the holed 50 yen coin.

He was also involved in the politics of Miletus and was sent as a leader to one of its colonies.

If you are a perfectionist, multiply the bore diameter by 0.82 and subtract this value from the tube length.

Pedro Doria was the blogger who scooped the story, first publishing the critical letter by Anderson, followed by Schelp's reply.

Optimally, the size of the aperture should be 1 100 or less of the distance between it and the projected image.

Pinhole cameras can be constructed with a sliding film holder or back so the distance between the film and the pinhole can be adjusted.

A maximum is 70 of bore width is possible in racing engines, where rings are changed every few races.

The pinhole may be punched or drilled using a sewing needle or small diameter bit through a piece of tinfoil or thin aluminum or brass sheet.

Sound is produced by the vibration of an air stream blowing across an open hole at the end of a resonating tube.

The ship's Gunner was informed, who in turn informed the captain...You may fire when ready...at the next high roll, the cannon would be fired.

When one pinhole is closed, the grid of wires causes appreciable diffraction in the light, and blocks a certain amount of light received by the corresponding photon detector.

In the U.S., however, the fat tends to be cut down at the butcher shop unless otherwise directed by the customer.

The ferret ( Mustela putorius furo ) is the domesticated form of the European polecat, a mammal belonging to the same genus as the weasel, Mustela of the family Mustelidae.

However, there is a mechanical limit to the width of a single exhaust port, at about 62 of the bore diameter for reasonable ring life.

In 1949, the current type of holed 5 yen was introduced, followed by bronze 10 yen (of the type still in circulation) in 1951.

It selects a point, it guides the drill to that point, it pierces the dry wall, leaving a half inch hole before traveling to the next location.

So we went over into Michael's garage his dad had all kinds of stuff, and we put a pipe in the vice there, and screwed a cap on the end of the pipe, drilled a hole in the back of the pipe, took some of our firecrackers, pulled out the fuses, tied them together, put them in the back there, and down in that hole and then stuffed some of our gunpowder down that pipe and put three ball bearings on the top, in the garage.

Breaking the news in the blogosphere, Carlos Serra reports that the police in Inchope intercepted a truck with 40 children between the ages of 7 and 11 years from Nampula, Mozambique.

It was reported as breaking news at GVO on May 23rd, translated into Portuguese and Chinese, and launched into global awareness via the blogosphere.

Cristine James from Boxoffice magazine gave the film 2 out of 5 stars, describing it as ... 'Alien' meets 'V' meets 'Splash' meets 'Playboy's Erotic Fantasies Forbidden Liaisons,' diluted into a diffuse, misdirected bore.

The correct tool to start a traditionally drilled hole (a hole drilled by a high speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit , as they are referenced in the U.S.).

In its simplest form, the photographic pinhole camera can consist of a light tight box with a pinhole in one end, and a piece of film or photographic paper wedged or taped into the other end.

What we've done, we've just sealed both the ends with tape, nipped the right corner and the bottom left corner, so there's holes in the opposite corners, there's a little hole over here.

Extraordinary. Unbelievable photo of one of the world's last uncontacted tribes TedBlog Extraordinary indeed.